产品中心
产品展示

  您当前的位置:首页 » 产品展示 » 色谱柱 » HH--CII 活性炭采样管

产品名称: HH--CII 活性炭采样管
产品型号: HH--CII
品牌: 1356
产品数量:
产品单价: 面议
日期: 2024-06-18

HH--CII 活性炭采样管的详细资料

活性炭采样管

HH--CII 活性炭采样管 详细信息:

不同原料烧制成的活性炭在性能上有一些差异。活性炭属于非性吸附剂,基本上以物理吸附为主,用来吸附非性和弱性的有机气体和蒸汽,它吸附容量大,吸附力强,但对水的吸附较少,因此,活性炭适合于采集有机气体和蒸汽混合物,特别适宜在浓度低,湿度高的地点长时间的采样。
活性碳采样管参数:
材质分为:玻璃和不锈钢两种

规格:Φ6×80、Φ6×120、Φ6×150、Φ6×180,Φ6×200

活性碳采样管可采集苯、甲苯、二甲苯、丁二烯、碘甲烷、甲烷、吡啶、三氯乙烷、环乙烷、乙苯等许多毒物。一般有两种型号:溶剂解吸型:即二硫化碳解吸型和甲醇解吸型。

CH3OH 溶剂解吸型:
规格为6 x 80 mm,内装处理好的20-40目活性碳150mg,共分为两段:前段为50mg,后段为100mg,溶封口两段直径约为2mm,该采样管与采样器配套使用。采样时在采样点用小砂轮打开采样管两端,50mg端与采样器进气口相连,然后根据需要调节好采样器流量和采样时间开始采样,采样结束后将采样管两端套上塑料帽密封,带回实验室用气相色谱仪处理分析。
其他规格可定做

活性炭采样管 图片:


同时供应:热解析仪,大气采样器,气相色谱仪,气体发生器,色谱柱,毛细管,填充柱,裂解进样器,氩离子检测器,实验室设备
HH - CII activated carbon sampling tube

There are some differences in the performance of activated carbon from different raw materials. Activated carbon is a non-polar adsorbent, basically based on physical adsorption, used to adsorb non-polar and weak polarity of organic gases and vapors, it adsorption capacity, adsorption strong, but less water adsorption, therefore , Activated carbon suitable for the collection of organic gases and steam mixtures, particularly suitable for low concentration, high humidity, long time sampling.
Activated carbon sampling tube parameters:
Material is divided into: glass and stainless steel two


Specifications: Φ6 × 80, Φ6 × 120, Φ6 × 150, Φ6 × 180, Φ6 × 200

Activated carbon sampling tube can be collected benzene, toluene, xylene, butadiene, methyl iodide, methane, pyridine, trichloroethane, cyclohexane, ethylbenzene and many other poisons. Generally there are two types: solvent desorption type: the carbon disulfide desorption and methanol desorption type.

CH3OH Solvent desorption type:
Specifications for the 6 x 80 mm, built-in treatment of 20-40 mesh activated carbon 150mg, is divided into two sections: the front section of 50mg, the latter paragraph of 100mg, melting sealing two diameter of about 2mm, the sampling tube and sampler use. Sampling at the sampling point with a small wheel to open both ends of the sampling tube, 50mg end connected with the sampler inlet, and then adjust the sampler flow and sampling time to start sampling, the sampling tube at both ends after the end of the plastic cap Sealed, back to the laboratory with a gas chromatograph analysis.
Other specifications can be customized
At the same time supply: thermal analyzer, atmospheric sampler, gas chromatograph, gas generator, column, capillary, packed column, pyrolysis sampler, argon ion detector, laboratory equipment